RecRoom Masters Graphic Kits

Graphic kits for reskinning or putting new graphics on RecRoom Arcade Cabintes found here https://recroommasters.com/

Here are some instructions on how to install new arcade graphics on a RecRoom Arcade cabinet, based on the information I found on the web:

Clean the cabinet with a mild detergent and a damp cloth. Make sure there is no dust, dirt, or grease on the areas where you will apply the new graphics. Let the cabinet dry completely before proceeding
Measure and cut the new graphics to fit your cabinet. You can use a ruler, a tape measure, and a pair of scissors or a utility knife to do this. Make sure you leave some extra margin around the edges for trimming later. You can also use a pencil to mark where you want to align the graphics on the cabinet
Peel off the backing paper from the new graphics and carefully align them on the cabinet. You can use masking tape or painter’s tape to hold them in place temporarily. Start from one corner and smooth out any air bubbles or wrinkles with your fingers or a squeegee as you go along
Trim off any excess material from the edges of the graphics with a utility knife or a razor blade. You can use a metal ruler or a straight edge to guide your cuts. Be careful not to cut into the cabinet or yourself
Enjoy your new arcade graphics! You can also add some protective plexiglass over the graphics if you want to make them last longer and look better.  Cabinets available at RecRoom Masters